BEFORE YOU BEGIN:

1) This product is specifically designed for installation on the outside of the vehicle.

2) Required Items embody an set up squeegee, masking tape, glass cleaner, dry paper towels, measuring tape or ruler.

three) Don’t apply any vinyl graphics in direct sunlight. Make certain it is between 60 degrees and 80 degrees F. Park the vehicle in the garage within the shade. Let cool for half-hour if hot.

four) Do not store unapplied graphics in direct sunlight – damage might occur.

5) All dirt, grease and wax have to be removed from the car surface earlier than the decal is applied. This contains wax from mechanical car washes, rain-x, compound, etc. Failure to take this step may end result in the decal not sticking to the vehicle surface.

STEP 1 – UNPACK THE SHIPPING CONTAINER – Remove decals from packaging. Lay decals flat on a smooth table in an space that is at the very least 60° F and beneath eighty° F.

STEP 2 – PREPARE THE SURFACE – An important step throughout decal set up is making positive the installation area is clean and dry. Make positive there is NO WAX, RAIN-X, COMPOUND, lint, dust, or other residue on the surface. Remove all wax, compound residue, automotive wash protestants, and so on with rubbing or denatured alcohol. After cleaning the surface, go over the surface with common glass cleaner.

STEP three – FIND DESIRED LOCATION OF THE STRIPES – Utilizing a string or different line, place it over the vehicle from the front to the back in the desired location for the stripes. Make sure that the string is symmetrically centered on the vehicle. Mark this location with a pencil of other nonpermanent marking device at the entrance and the rear of every body panel. This will serve as the location of the sting of the stripes.

STEP four – PLACE THE STRIPES – Measure the length of every body panel to which the stripe is to be applied. Lay the stripe part over the world of the vehicle, trimming the excess stripe off one finish (depart not less than an inch extra) Save all lower off items, as they can be used to cover bumpers and fins.

STEP 5 – SECURE THE STRIPES – Place a strip of masking tape at one end of the stripe, as this will hold the end of the stripe while installing. Working from that end to the opposite, slowly peel back the discharge paper half of way down and spray the body surface with a fine mist of water answer (not soapy answer). With a squeegee, apply the stripe to the body panel working from the middle of the stripe outward. As you work further down the stripe, slowly proceed to remove the backing paper as needed. Slowly continue to use the stripe with the squeegee, applying even pressure throughout the width of the stripe.

STEP 6 – REMOVE THE TRANSFER PAPER – Once the complete piece is applied, remove the masking tape from the end of the stripe. Subsequent remove the transfer tape covering, careabsolutely pulling parallel to the surface of the vehicle (NOT UP BUT SIDEWAYS).

STEP 7 – FINISH INSTALLATION – Any small air pockets might be simply removed by first placing a small hole within the bubble (small hole, zgripceanu01 not massive slice). Then moisten the squeegee edge with water and slide the squeegee along the surface of the stripe the place the bubble is, working the air towards the hole.

CARE AND MAINTENANCE:

Once the decal is installed, to keep it looking new, simply wash it everytime you wash the vehicle. You possibly can apply automotive wax, clearcoat, or RainEx over the decal as soon as it is applied. your new decal gives you years of nice looks. In case you are in cold climate be careful when using an ice scraper on any surface the place decals are applied.