The Prius is a great car to own but when the estimated life of the battery expires, this causes a major problem to the owner. The Toyota Prius battery cost is very high. It is even costlier than the complete engine of a car. The Toyota Prius battery cost is somewhere in the range of $4000. This price is hardly affordable by all the customers who own a Prius. The Toyota Prius battery cost, being so high, forms a really good reason for people to look for other options.

overhaul a care engine Disconnect the vacuum advance and hit the timing mark with the timing light. A good setting is 8-10 degrees before top dead center (BTDC). To adjust timing, loosen the distributor clamp and simply rotate the distributor accordingly.

Now take a look at the fender to door gaps, they to should be uniform and be 1/16″ to 1/8″ wide. If they are not the car has been wrecked and the panels have been pushed in, or pulled out.

build a car engine The great thing about this is the fact that it is easy to do. You just need some electrodes, a power source and a couple of other little bells and whistles and you can create HHO on demand and really run a car on water… or at least the basic building blocks of water!

By using this technology, you can save up on fuel costs because your vehicle will then need a lower quantity of gasoline. Not only that, it also contributes to environment conversation as running a car on water can reduce the amount of carbon emissions released into the air.

rebuild a car engine In order to get this to work you’ll need to install a converter within the engine compartment. Sounds hard but it’s really not. Then alls you need to do is add water and baking soda and run electric to your car battery. This will cause the water molecules to break down into their simple HHO formula. This process is necessary because water cannot by itself act as a fuel supplement. The hydrogen within the water needs to be extracted by this process.

After that, take the water caps off the dead battery to look at the water level, which needs to be at least mid-way up the port. In any other case, add water in order to refill the ports prior to jumping the battery. You should use a piece of cloth or rag to wipe off the cable connectors in order to get rid of any acid corrosion or build-up.